Makita VR001G Manuel D'instruction page 6

2. Loosen the screws securing the standard
equipped battery case, and slide the battery case off
along the housing.
3
1
Fig.2
► 1. Standard equipped battery case 2. Screws
3. Housing
3.
Slide an optional battery case into the tool. Open
the case while pressing the buttons on sides of the
case. Then tighten the screws to secure it in place.
1
Fig.3
► 1. Optional battery case 2. Screws
4. Close the battery case securely.
Installing and removing battery
cartridge
CAUTION:
battery cartridge, always make sure to set the
switch trigger back into the "OFF" position by
pulling the switch trigger fully and releasing it.
2
CAUTION:
tridge firmly when installing or removing battery
cartridge. Failure to hold the tool and the battery
cartridge firmly may cause them to slip off your hands
and result in damage to the tool and battery cartridge
and a personal injury.
CAUTION:
fully until the red indicator cannot be seen. If not,
it may accidentally fall out of the tool, causing injury to
you or someone around you.
CAUTION:
forcibly. If the cartridge does not slide in easily, it is
not being inserted correctly.
CAUTION:
between the battery case and its front cover while
installing and removing battery cartridge.
Installation
1. Open the battery case while pressing the buttons
on sides of the battery case.
2
1
Fig.4
► 1. Battery case 2. Buttons
6 ENGLISH
Before installing and removing
Hold the tool and the battery car-
Always install the battery cartridge
Do not install the battery cartridge
Take care not to trap your fingers
2