Makita VR001G Manuel D'instruction page 12

Installing shoulder strap
Optional accessory
WARNING:
Always remove the shoulder strap
from the tool while wearing portable power packs.
Wearing multiple harnesses and straps may impair
the chances to take the equipment off quickly in a
case of emergency and result in personal injury.
WARNING:
Do not use the parts for attaching
the shoulder strap for other purposes, such as
the fall prevention at high location. If the parts
for attaching the shoulder strap are used for other
purposes, excessive load may break them and cause
serious injury to the operator and person around/
underneath the operator.
CAUTION:
Be sure to attach the hooks of the
shoulder strap to the tool securely. If the hooks are
attached incompletely, they may come off and cause
injury.
CAUTION:
Be sure to use the shoulder strap
dedicated to this tool. Using other shoulder strap
may cause an injury.
Hang the hooks of the shoulder strap over the hanging
holes on top of the tool.
Fig.22
► 1. Shoulder strap 2. Hook 3. Hanging hole
OPERATION
CAUTION:
shoulder, and hold the tool firmly with both
hands.
NOTICE:
flexible shaft tends to vibrate at a higher ampli-
tude. The tool will restore the normal amplitude
after you squeeze and release the switch trigger a
few times repeatedly.
Make sure to throw in and keep the vibration head stand straight
during operation. Use the tool within the effective vibration
ranges at equidistant intervals. The effective air bubble removal
range is approximately ten times the diameter of vibration head.
1
Fig.23
2
3
Fig.24
NOTICE:
in the formwork. The mortar will just move away
and the coarse aggregate will remain, causing
segregation.
Fig.25
12 ENGLISH
Put the shoulder strap on the
At the very beginning of operation, the
Do not use the tool to move concrete