Faber GALILEO BK A830 Manuel D'utilisation page 13

Error code
ER 03 and Continuous sensor
continuous tone
after 10 sec
ER20 Flash memory – TC error
ER22 Button evaluation
after 3.5-7.5 sec
ER31
data or deviation between
generator and TC
ER36 NTC value defective on
ER47 Communication error
between TC and induction
U400 Continuous tone Power
supply on inlet to high
E/2
the induction element
E/A Error on the power board
E/6 Error on power board
E/8 Incorrect fan speed
E/9 Defective temperature
sensor on inductor
8. MAINTENANCE AND REPAIR
- Make sure that maintenance on electrical
components is carried out only by the
manufacturer or the customer service.
- Make sure that damaged cables are changed
only by the manufacturer or the customer service.
provide the following information:
- type of fault
- appliance model (Art./Cod.)
- serial number (S.N.)
This information is given on the data plate. The
data plate is attached on the bottom side.
Error codes
Description
over the touch control sensors
Short or open circuit in the area
of the button sensoric
induction generator required
Short or open circuit of NTC
No or erroneous LIN
communication! (Slave does not
answer to request of master)
Incorrect connection of the
cooktop
Overload of cooktop or empty
boiled cookware
Component failure
No power supply or error on
power board
Error on fan left or right
Possible cause of error
9.TECHNICAL DATA
Type: 4300
Model: GALILEO BK A830
Refer to the data plate placed on the bottom side
of the product.
The manufacturer provides continuously product
the illustrations in this manual may be changed
without notice.
Further information on technical data is available
on: www.faberspa.com
Remedy
Clean the control surface,
remove objects on the
sensors.
Replace TC
Replace TC
menu)
Replace TC
Connection cable not correctly
plugged in or defective.
Correct power supply
connection
Let system cool down.
Replace power board
1. check wiring
3. replace power board
paper Replace Defective fan
Replace inductor Replace
power board
11