Hürner WeldControl EF 315 Manuel Utilisateur page 44

"Weather Conditions on" means that the weather has to be selected
in a list before every welding, "off," that this is not possible.
"Installing Company on" means that the company that performs the
installation work has to be entered before every welding, "off,"
that this is not possible.
"Print Tags – M – " means that by pressing the MENU key, the user
can access a sub-menu for starting to print (a) label(s) with refer-
ence to a given welding operation, with the optional label tag
printer.
"Angle – M – " means that by pressing the MENU key, the user can
access a sub-menu for entering the angle, in degrees, between
the two components that are going to be welded.
All data that are available in the chip of a transponder card
can be entered by placing the card in front of the card reader.
If they are encoded in a bar code, they can be read using the
Info handheld scanner.
4.2 Entering Preformatted and User-defined Traceability Data
When the system is used for the electrofusion process or the butt-
welding process in the WeldControl mode, all traceability data enabled
in the configuration menu at "Recording" (see Sect. 4.1.6) have to be
entered before the welding process. The welding unit prompts the
user to enter them before the welding process proper. Depending on
what data is entered, either its repeated input is mandatory (e. g.,
the welder ID code; see Sect. 4.1.2) or previously entered data can be
changed and confirmed or confirmed without changes (e. g. the com-
mission number; see Sect. 4.2.2).
4.2.1 Entering the Welder ID Code
When the welding is started by pressing the START/SET key while Dis-
play 3 is showing, first the input of the welder identification code is
requested, if it is enabled in the Configuration Menu (see Display 11).
The code has to be an ISO-compliant code. It can be entered either
using the alphanumeric keypad (see the first info in Sect. 4.1) and
confirming the input by pressing the START/SET key, or by reading a
RFID transponder card or scanning it from a bar code with the optional
handheld scanner.
When the code was properly scanned or entered, this is confirmed by
an audible signal.
4.2.2 Entering or Changing the Commission Number
From Display 3 or after the welder identification code was entered, the
machine requests the input of the job number, or commission number,
of a maximum 32 characters if it was enabled in the Configuration
Menu. If a commission number exists already in memory, this one is
proposed. You can either confirm it by pressing START/SET or change
it using the alphanumeric keypad (see the first info in Sect. 4.1) or
reading it with the optional scanner or from a RFID card and then
confirm the new number by pressing the START/SET key.
It is possible to select a previously saved commission number instead
of the one shown on the screen by pressing the ï and ð cursor keys
simultaneously. This causes the screen to show in which you can scroll
through the commission numbers in memory using the ï and ð keys,
to select a number and then confirm it by the START/SET key. This
number will be used for the next welding. To quit the scroll mode
without selecting a commission, press the STOP/RESET key.
16
EN
HÜRNER WeldControl EF 315 User's Manual
H Ü R N E R S c h w e i s s t e c h n i k G m b H
Nieder-Ohmener Str. 26
35325 Mücke, Germany
Enter Welder Code
++++++++++++++++++++
++++++++++
Enter Commission No.
++++++++++++++++++++
++++++++++++
Version January 2018
Display 11
Display 12