Stihl MS 362 Notice D'emploi page 37

1
Pull the retainer (1) upwards to the
N
rear, tilt air filter in direction of rear
handle and lift it away.
Always replace damaged filters.
N
Versions with fleece filter and felt
prefilter
2
1
Separate the felt prefilter (1) from
N
the fleece filter (2) and clean – see
below.
Cleaning the air filter
Knock the filter out on the palm of
N
your hand or blow it clear with
compressed air from the inside
outwards.
If filter is caked with dirt:
Wash the filter in STIHL special
N
cleaner (special accessory) or a
clean, non-flammable solution (e.g.
warm soapy water) and then dry.
MS 362
NOTICE
Do not use a brush to clean the fleece
filter.
The felt element protects the fleece filter
and prolongs its useful life. It should
therefore be replaced at more frequent
intervals than the fleece filter.
Installing the air filter
Push the felt prefilter over the fleece
N
filter and press it home at all four
corners – only versions with fleece
filter and felt prefilter.
2
1
Engage the tabs (1) in the
N
recesses (2).
Swing the air filter in the direction of
N
the filter housing and lock with
retainer.
Fit the shroud.
N
Engine Management
Exhaust emissions are controlled by the
design of the fundamental engine
parameters and components (e.g.
carburation, ignition, timing and valve or
port timing) without the addition of any
major hardware.
English
35