Publicité
FRONT BRAKE SHOE INSPECTION (TT-R125/TT-R125E)
Connect the transparent hose 4 to the
G
bleed screw 5 and place the suitable con-
tainer under its end.
Loosen the bleed screw and push the
G
brake caliper piston in.
CAUTION:
Do not reuse the drained brake fluid.
Tighten the bleed screw.
G
Bleed screw:
6 Nm (0.6 m • kg, 4.3 ft • lb)
Install the brake caliper 6 and brake cali-
G
per support bolt 7.
NOTE:
Apply the lithium soap base grease on the
caliper support bolt.
Brake caliper support bolt:
22 Nm (2.2 m • kg, 16 ft • lb)
4. Inspect:
Brake fluid level
G
Refer
INSPECTION" section.
5. Check:
Brake lever operation
G
A softy or spongy feeling → Bleed
brake system.
Refer
BLEEDING" section.
FRONT BRAKE SHOE INSPECTION
(TT-R125/TT-R125E)
1. Inspect:
Brake shoe lining wear limit
G
Brake shoe lining wear limit checking
steps:
Fully pull in the brake lever and hold it in
G
position.
Then check the brake shoe wear indicator
G
1 is within the wear limit a.
Outside the limit →
Refer to "FRONT WHEEL AND FRONT
BRAKE" section in the CHAPTER 5.
3 - 19
INSP
ADJ
to
"BRAKE
FLUID
to
"BRAKE
SYSTEM
Replace the brake
shoe.
LEVEL
AIR
Publicité
