Nice NDCC4001 Guide Rapide page 15

L2 Operation
modes
L3 Motor
speed
L4 Output 1 (MOS)
L5 Output 3 (relay)
Output
L6
traffic light
L7 ING1
Delay
L8 brake deactiva-
tion
Note: " " represents the factory adjustment
L1 S.S. : Open – stop – close - stop
L2 S.S. : Open -stop - close - open
L3 S.S. : Open – close - open - close
L4 Step-Step 2 (less than 2 sec. generates partial opening).
L5 Apartment block 2 (more than 2 sec. generates Stop)
L6 Apartment block
L7 Hold-to-run
Opening in "semi-automatic mode", closing in "hold-to-run"
L8
mode
L1
Speed 1: 80%
L2 Speed 2: 100%
L3 Speed 3: 140%
L4
Speed 4: 180%
L5 Speed 5: Open 80%, close 50%
L6 Speed 6: Open 100%, close 50%
L7
Speed 7: Open 140%, close 60%
L8 Speed 8: Open 180%, close 60%
L1 Door Open Indicator
L2
It activates if the door is closed
L3 It activates if the door is open
L4 Flashing light
L5
Electric block
L6 Flashing light 24
L7 Suction cup
L8
Maintenance indicator
L1 It activates if the door is closed
L2 It activates if the door is open
L3
Courtesy light
L4 Electric block
L5 Radio channel 1
L6
Radio channel 2
L7 Radio channel 3
L8 Radio channel 4
L1
Red traffic light
L2 Green traffic light
L3 One-way traffic light
L4
Flashing light one-way
L5 Two-way traffic light
L6 Door open indicator
L7
Status
L8 Maintenance indicator
L1 Step Step (normally open contact)
L2
Partial Ap 1 (normally open contact)
L3 ALT (normally closed contact)
L4 Foto (normally closed contact)
L5
Foto1 (normally closed contact)
L6 Foto2 (normally closed contact)
L7 Foto3 (normally closed contact)
L8
Emergency (normally closed contact)
L1 0, 0, 0, 0 instant activation
L2 20, 20, 0, 0
L3
50, 50, 20, 20
L4 100, 100, 50, 50
L5 150, 150, 100, 100
L6 200, 200, 150, 150
L7 250, 250, 200, 200
L8 300, 300, 250, 250
It assigns the operation modes.
Sets the motor speed during normal trav-
el of the motor with inverter.
Selects the device connected to output 1
piloted at MOS.
Selects the device connected to output 3
piloted at RELAY.
Selects the device connected to the traf-
fic light output.
Selects the function to be associated to
input ING1
Select the delay time in "ms" for brake
deactivation for:
- opening
- closure
- opening stop
- closure stop
5