Environmental Instructions And Disposal Information; Declaration Of Conformity; Machinery Directive - Parkside PDBS 6.2 A1 Instructions D'utilisation Et Consignes De Sécurité

... / Environmental instructions and disposal information / Declaration of Conformity
The product number can be found on the type plate, an
engraving, the cover page of your instructions (bottom
left) or the decal at the back or bottom. In the event
of malfunctions or other defects, please first contact
the service department below by phone or e-mail.
A product recorded as defective, along with the proof
of purchase (sales receipt) and a description of the
defect and when it occurred, can then be returned
free of charge to you to the service address provided.
Note:
Visit www.lidl-service.com to download
this and many other manuals, product
videos and software.
How to contact us:
GB
Name: C. M. C. GmbH
Website: www.cmc-creative.de
E-mail: service.gb@cmc-creative.de
Phone: 0-808-189-0652 (standard
German landline rates apply)
Fax: 0-808-189-0652
Registered office: Germany
IAN 275681
Please note that the following address is not a ser-
vice address.
Please first contact the service point named above.
Address:
C. M. C. GmbH
Katharina-Loth-Str. 15
66386 St. Ingbert, Germany
Environmental instructions
and disposal information
Don't waste, recycle!
Device, accessories and packaging
should be recycled in an environmentally
friendly manner.
50 GB
Do not dispose of the air tool with your household
waste, or throw into fire or water. If possible, non-
operational equipment should be recycled. Contact
your local retailer for information.

Declaration of Conformity

We,
C. M. C. GmbH
Responsible for documentation: Daniel Havener
Katharina-Loth-Str. 15
66386 St. Ingbert
declare in our sole responsibility that the product
Pneumatic metal shears
Item number: 1942
Year of manufacture: 2016 / 34
IAN: 275681
Model: PARKSIDE PNEUMATIC METAL
SHEARS PDBS 6.2 A1
meets the basic safety requirements of European
Directives

Machinery Directive

EC Directive 2006 / 42 /EC
and its amendments.
The conformity assessment is based on the following
harmonised standards:
EN ISO 11148-11:2011
St. Ingbert, 31.05.2016
p.p. Daniel Havener