Sportplus SP-HT-1004-iE Mode D'emploi page 46

8. TROUBLESHOOTING – PROBLEMS WITH THE COMPUTER DISPLAY
"No function values are displayed. Only the pulse display is working."
This could mean there is transmission interference between the home trainer and the
computer. Check to see that all cables are properly connected to one another and that
none of the cables is damaged.
"The pulse display does not work anymore / always displays P."
If all other computer function values are being displayed, then the problem is either the hand
sensor or the cable connection between the sensor and the computer. Check to see that
all cables are properly connected to one another and that none of the cables is damaged.
TROUBLESHOOTING
WARNING RISK OF INJURY
Improper repairs can result in significant hazards for the user. Any repairs or replacements
must be carried out by a technically experienced person.
Problem
The pulse display is not
working correctly.
The display of the
computer malfunctions or
is defective.
Squeaking noises.
E1 Monitor cannot read
the signal from the gear
motor (Level change
cannot reach target
position)
02-SP-HT-1004-GB_NEUEST.indd 46 02-SP-HT-1004-GB_NEUEST.indd 46
Cause
Improper wiring.
Bad contact with the
hands.
There could be a
transmission error
between the product and
the computer.
Connections (bearing
bushings) are dry.
Monitor has a problem
The connection cables
from monitor
to gear motor are
damaged or
disconnected. Pins of the
connector
are bent or not fix well.
46
Solution
Check to see that all cables
are properly connected to one
another and that none of the
cables is damaged.
Moisten your hands.
Check to see that all cables
are properly connected to one
another and that none of the
cables is damaged. Check
the plug connections on the
product and the power plug in
the power outlet.
Grease the bearing bushings.
Replace monitor
Check all computer plugs and
wires are connected firmly.
07.06.23 11:43 07.06.23 11:43