Sportplus SP-HT-1004-iE Mode D'emploi page 32

INFORMATION ON ASSEMBLY
• The product should be carefully assembled by a responsible adult. Ask for the assistance
of another, technically-skilled person in case of doubt.
• Before beginning assembly of the product, read all assembly steps carefully and
review the diagram.
• Remove all packaging materials and lay out all the parts. This will give you a good
overview and simplify assembly. Shield the assembly surface from filth and scratching
by laying down suitable padding.
• Check the components against the components list to make sure all are present. Do
not dispose of all packaging materials until assembly is completed.
• Please note that there is always a risk of injury when using tools to carry out manual
tasks. Therefore, please exercise caution when assembling this product.
• Make sure your work environment is hazard-free. For example, do not leave any tools
lying around. Place the packaging materials somewhere where they will not pose any
hazards during assembly. Packaging foil or plastic bags pose a suffocation hazard
for children!
• After assembling the product according to the instructions, make sure that all screws,
bolts, and nuts are installed correctly and tightened.
• Regularly check the screw connections and tighten them when necessary.
• If necessary, lay out protective padding (not included) beneath the product to protect
your floor as there is no guarantee that, for instance, the rubber feet will not leave
marks behind.
• Some of the screws and nuts are self-locking. This mechanism may be damaged if
they are loosened. To ensure the screws/nuts hold tightly, check them before assembly
and, if necessary, coat them in a securing lacquer or use new self-locking hardware
(available in a building supplies store).
02-SP-HT-1004-GB_NEUEST.indd 32 02-SP-HT-1004-GB_NEUEST.indd 32
32
07.06.23 11:43 07.06.23 11:43