Gesipa FireFox Mode D'emploi page 28

GB
Set nut is loose
Cause
Setting stroke "Y" too short
Setting force too low
Air pressure too low
8. Notes on environment
Dispose of hydraulic waste oil according to current environmental regulations.
Observe regulations about dangerous substances!
9. Repairs
Repairs under warranty are carried out by the manufacturer. Repairs outside the warranty
period should only be carried out by skilled technical personnel. Failure to observe the
assembly and setting procedures and operation by non-skilled personnel may result in seri-
ous damage to the blind rivet setting tool. In case of doubt, always send the blind rivet set-
ting tool back to the supplier or to GESIPA
You can find the current spare parts list for your tool online at www.gesipa.com.
10. Warranty
The applicable terms and conditions of guarantee shall apply and can be viewed under following
link: www.gesipa.com/agb
28
Remedy
Increase setting stroke (see item 4.1)
Increase setting force (see item 4.2)
Increase air pressure to 5-7 bar
.
®