Gesipa FireFox Mode D'emploi page 21

2.5 Equipment / accessories
Threaded man-
drels
Nosepiece
Tool
Suspension loop
Hydraulic oil
Other
3. Starting procedure
Prior to operating the blind rivet nut setting tool, attach the relevant threaded mandrel with
nosepiece to match the thread size.
3.1 How to change a threaded mandrel
• Disconnect the blind rivet nut setting tool from the compressed air network.
• Detach locknut A, using double open-end spanner SW27.
• Unscrew nosepiece B with locknut A
• Push slide H back all the way to buffer and hold tight
• Unscrew threaded mandrel C
• Insert new threaded mandrel of same size (if worn out) or threaded mandrel of matching
thread size all the way to buffer.
• Release slide. At the same time make sure that the threaded mandrel is locked safely
inside the hexagon socket of the slide. If required, unscrew threaded mandrel slightly until
the slide locks.
• Insert a matching nosepiece for each thread size using locknut A and lock loosely with
locknut, using a double open-ended spanner.
• Set threaded mandrel length "X", as described under item 3.2.
FireFox
M3, M4, M5 und M6
M3, M4, M5 und M6
2 x double open-end spanner SW24/27
1 bottle of hydraulic oil 100ml (Part no. 1445294)
1 oil filling container (Part no. 1625612)
2 cards for quick setting (quick setting
card part no. 1626111 + colour code
part no. 1742880)
1
®
Hexagon screw driver SW3
Extendable from device top
2 cards for quick setting (quick setting
card part no. 1626263 + colour code part
FireFox 2
®
M4, M5, M6 und M8
M4, M5, M6 und M8
no. 1458192)
GB
21