Adjusting The Screen Display; Resetting All Adjustment Values; Adjustment Lock Function; Adjusting The Backlight - Sharp LL-T18A1 Mode D'emploi

Adjusting the screen display

For analog signal
1.First perform an automatic adjustment. (p.14)
2.Perform manual adjustment where necessary.
(p.15)
For digital signal
The monitor can generally be used without
adjustment. If necessary perform manual adjust-
ment. (p.18)
Note:
- All adjustments will be saved even after turning
the power off.

Resetting all adjustment values

All adjustment values can be returned to their
original ex-factory values in one command.
1. Turn off the monitor power.
2. Press the MENU button and the
simultaneously, and while doing this press the
power button (i.e. turn the power on). When [ALL
RESET] appears on the screen, the reset is
complete.
Notes:
- While [ALL RESET] is displayed, the control
buttons are disabled.
- It is not possible to reset values when the
adjustment lock is in place. Remove the
adjustment lock before attempting to operate
control buttons.

Adjustment lock function

By disabling the control buttons (i.e. setting the
lock) any attempted changes to adjusted values will
be voided.
1. Turn off the monitor power.
2.While pressing the MENU button, press the
power button (i.e. turn the power on).
Continue to press the button until [ADJUSTMENT
LOCKED] appears on the screen.The lock is set
when the message is displayed.
Note:
- When the lock is in place, all buttons other than
the power button are disabled.
Adjustment lock release
1. Turn off the monitor power.
button 2.While pressing the MENU button, press the
power button (i.e. turn the power on).
Continue to press the button until [ADJUSTMENT
UNLOCKED] appears on the screen.The lock is
released when the message is displayed.

Adjusting the backlight

1. Without the OSD Menu being displayed, press
the
screen the BRIGHT bar will appear.
2. Adjust by pressing the
button (lighter).
3.Press the MENU button.
The BRIGHT bar disappers.
- The BRIGHT bar automatically disappears
several seconds after the last command.
13
or the button. At the bottom of the
button (darker) or