Scheppach BKS5300S Traduction Des Instructions D'origine page 51

Every week Fan housing
Cylinder space
Spark plug
Muffler
Spark arrester screen
Chain catch sleeve
Screws and nuts
Every 3 months Fuel filter
Fuel, oil tank
Storage Chain saw
Guide bar/ chain
Fuel, oil tank
Carburretor
Service information
Please note that the following parts of this product
are subject to normal or natural wear and that the fol-
lowing parts are therefore also required for use as
consumables.
Wear parts*: Saw chain, Guide bar, Saw chain oil, En-
gine oil, Spiked bumper, Chain
air filter, fuel filter, saw chain oil filter
* Not necessarily included in the scope of delivery!
Spare parts and accessories can be obtained from
our service centre. To do this, scan the QR code on
the cover page.
11. Storage
m CAUTION!
Never put a chain saw into storage for longer than 30
days without carrying out the following steps.
Follow the cleaning instructions and maintenance in-
structions before storing the device.
Storing a chain saw
Storing a chain saw for longer than 30 days requires
storage maintenance. Unless the storage instruc-
tions are followed, fuel remaining in the carburetor
will evaporate, leaving gum-like deposits. This could
lead to difficult starting and result in costly repairs.
• Remove the fuel tank cap slowly to release any
pressure in tank. Carefully drain the fuel tank.
• Start the engine and let it run until the unit stops
to remove fuel from carburetor.
• Allow the engine to cool (approx. 5 minutes).
• Remove the spark plug.
• Pour 1 teaspoon of clean 2-cycle oil into the com-
bustion chamber. Pull starter rope slowly several
times to coat internal components. Replace spark
plug.
Clean to ensure proper air cooling
Clean
Check and replace if necessary
Check tightness of mounting
Clean
Check for damage, replace if necessary.
Check their condition and that they are firmly secured.
Replace
Clean
Clean exterior, check for damage. In case of damage, have
repaired by a qualified service center immediately
Demount, clean and oil slightly
Clean the guide groove of the guide bar
Empty and clean
Run empty
catcher, Spark plug,
www.scheppach.com
m NOTE
Store the unit in a dry place and away from possible
sources of ignition such as a furnace, gas hot water
heater, gas dryer, etc.
Putting the saw back into operation
• Remove spark plug.
• Pull starter rope briskly to clear excess oil from
combustion chamber.
• Clean the spark plug and check that the electrode
gap is correct.
• Prepare unit for operation.
• Fill fuel tank with proper fuel / oil mixture.
12. Transport
To transport the chain, empty the fuel tank. Remove
coarse dirt from the saw with a brush or a hand
brush.
13. Disposal and recycling
Notes for packaging
The packaging materials are
recyclable. Please dispose of
packaging in an environmen-
tally friendly manner.
You can find out how to dispose of the disused
device from your local authority or city adminis-
tration.
Fuels and oils
• Before disposing of the unit, the fuel tank and the
engine oil tank must be emptied!
• Fuel and engine oil do not belong in household
waste or drains, but must be collected or disposed
of separately!
• Empty oil and fuel tanks must be disposed of in
an environmentally friendly manner.
GB | 51