Publicité
Les langues disponibles
Les langues disponibles
Attention!
•
The hob must be installed by a qualified electrician in line with all local
standards and regulations for electrical wiring.
•
Before any work on the electrical section of the appliance, it must be
disconnected from the mains.
•
Connection to a good earth wiring system is absolutely essential.
•
All supply current and earth conductors must be able to withstand an
ambient temperatureof 75°C.
•
After the hob is installed, the power switch must always be in an accessible
position.
The wires in the mains lead are coloured in accordance with the following codes:
Green & Yellow = Earth
The appliance is equipped with a pre-connected electricity supply cable without
plug. Separate the wires of the supply cable and connect them in accordance
with the instructions given in the below diagram.
1.
The wire which is coloured green and yellow must be connected to the
terminal marked with the letter E (Earth) or with the earth symbol
coloured green and yellow.
2.
The wire which is coloured blue must be connected to the terminal marked
N (Neutral).
3.
The Brown and Black wires must be connected to the terminal marked L
(Line).
• If the appliance is being connected directly to the electricity mains, an
omnipolar circuit breaker with a minimum opening of 3 mm between
contacts must be fitted between the appliance and the electricity supply
in compliance with the load and current regulations.
• The installer must ensure that the correct electrical connection has been
made and that it is fully compliant with safety regulations.
ELECTRICAL CONNECTION
Blue = Neutral
Brown & Black = LINE
or
73
Publicité
