Hot Swap Drive - Promise Technology SUPERSWAP 4100 Manuel Utilisateur

The switch is located on the back of the SuperSwap enclosure (see above).
ON is to the left, OFF is to the right.
The ON setting spins up the first two disk drives at the same time, then a
two-second pause before spinning up the third disk drive, then another two-
second pause before spinning up the fourth disk drive.
The OFF setting causes SuperSwap to spin up its disk drives when the
power comes on.
12. Replace the computer's cover and reinstall the power cord.

Hot Swap Drive

The Promise SuperSwap 4100 is designed to work with the Promise FastTrak
Serial ATA RAID controllers that support RAID 0, RAID 1, RAID 5 and RAID 10,
such as the FastTrak S150 SX4. When used with the supported SATA RAID
controllers, SuperSwap 4100 enables hot swapping of disk drives.
Hot swapping means you can remove a drive while your system is operating and
replace it with another. You perform a hot swap when one of the drives has failed
and needs replacement. The PAM Software reports drive problems and identifies
which drive, by Channel (Port) number, needs replacement.
In all other cases, before you remove or install a disk drive, power
down your system and ground yourself. Failure to do so may
result in damaging the drive, the controller card or other
components and could result in data loss.
Caution
15
Chapter 2: Installation