Chapter 2: Installation; Unpack Your Superswap 4100; Install The Enclosure - Promise Technology SUPERSWAP 4100 Manuel Utilisateur

Chapter 2: Installation

• Unpack your SuperSwap 4100 (below)
• Install the Enclosure (below)
• Install a disk drive (page 16)
• Remove a disk drive (page 17)

Unpack your SuperSwap 4100

The SuperSwap 4100 box contains the following items:
• SuperSwap Drive Enclosure •
• (4) Drive Carriers
• User Manual
• 3-pin to 3-pin SMBus Cable
(SATA II compliant)
There are two phases to install the SuperSwap 4100 into your computer:
• Install the enclosure in your computer chassis
• Install a disk drive in the drive carrier

Install the Enclosure

To install the enclosure in your computer chassis, follow these steps:
1. Power down your computer and unplug the power cord.
2. Remove the computer cover.
3. Arrange the drive assemblies to arrange for three contiguous, free 5.25-inch
drive bays. Remove any bezels covering them.
SuperSwap 4100, like other parts of your system, is subject to
damage by static electricity. Be sure that youíre properly grounded
(Promise recommends that you wear an anti-static strap or touch
a grounded object) and that you unplug your system before
installing SuperSwap 4100 or handling its components.
3-pin to 4-pin SMBus Cable
• 6-pin to 6-pin Daisy Chain Cable
• (16) Screws to attach disk drives to
drive carriers
• (8) Screws to mount Enclosure into PC
chassis
Warning
9