Promise Technology SUPERSWAP 4100 Manuel Utilisateur page 19

Daisy Chain
IN Connector
Management
Connector
Daisy Chain
OUT Connector
Daisy Chain
6-pin Cable
To Daisy Chain IN
Connector of next
SuperSwap 4100
Step 10 applies to the FastTrak RAID Controller only. If you have a SATA
150 Controller, go to Step 11.
10. Connect the 3-to-4 pin or 3-to-3 pin SMBus cable from the Management
connector on the FastTrak Controller card to the Management connector on
the back of the housing assembly.
If you are installing multiple SuperSwap 4100s, connect the SMBus cable to
the first SuperSwap as described in Step 10. Then install a 6-pin daisy-chain
F a s t T r a k
13
Chapter 2: Installation
SuperSwap
4100
SMBus 3-pin to
4-pin Cable or
SMBus 3-pin to
3-pin Cable
Management
Connector
S X 4
1 5 0
FastTrak S150 SX4
Controller Card
J 1