ENGLISH
MACHINE START AND STOP
Starting the machine
1.
Prepare the machine as shown in the previous paragraph.
2.
Turn the solution flow control switch (37) to one of the following positions, according to the type of cleaning to be performed:
•
One drop: chose this position to clean floors which are not very dirty; in this condition the machine can work with an
autonomy of 50 minutes (0.25 litres/min average).
•
Two drops: chose this position to clean floors which are quite or very dirty; in this condition the machine can work with an
autonomy of 25 minutes (0.5 litres/min average).
3.
Turn the knob (32) to the suitable program.
•
(33) brush - vacuum system - solution flow activation
•
(34) brush - solution flow activation
•
(35) vacuum system activation
4.
While keeping the hands on the handlebar (1), start the machine by pressing the enabling push-button (39) together with the
brush levers (40).
NOTE
If the green warning light (38) turns on, the machine is ready to be used. If the yellow or red warning light turns on, the
battery must be charged (see the procedure in Maintenance chapter).
Stopping the machine
5.
Release the brush levers (40) and the enabling push-button (39).
6.
Turn the knob (32) to "0" position to switch off the machine.
MACHINE OPERATION (SCRUBBING/DRYING)
1.
Start the machine as shown in the previous paragraph.
2.
While keeping both hands on the handlebar (1), move the machine and start scrubbing/drying the floor.
3.
If necessary, adjust the solution quantity by using the switch (37).
CAUTION!
To avoid damaging the floor surface, do not use the brush without the solution and, when the machine is not
operating, stop the brush/pad-holder by releasing the levers (40).
CAUTION!
Before lifting the brush/pad, turn it off by releasing the levers (40).
NOTE
For correct scrubbing/drying of floors at the sides of the walls, Nilfisk Alto suggests to go near the walls with the right side
of the machine as shown in figure 2.
12
USER MANUAL
A
SCRUBTEC 337
Figure 2
B
9099222000
P100449