T Removing Seat Rails; Seat Saddle Adjustment; Sideguard Hardware - Quickie Q2 Lite Mode D'emploi

Q UI C KI E 2 L ITE
T. REMOVING SEAT RAILS
Detach seat rails by removing the two bolts (G) attaching the seat rail (F) to the cross brace.
U. SEAT SADDLE ADJUSTMENT
The Quickie 2 features two seat rail connection settings using a reversible seat saddle (C). The "dynamic" posi-
tion (shown) allows for a more rigid seat rail connection. The "classic" position (not shown) provides the cur-
rent tension ideal for folding and unfolding the chair.
To adjust the saddle into either "classic" or "dynamic" position, simply remove the allen bolt (D), reverse the
saddle (C) and retighten.
V. SIDEGUARD HARDWARE
Installation of sideguard hardware
a. Position outer receiver hardware (E) on frame.
b. On corresponding inside of the frame position inner clamping hardware (F)
c. Insert two bolts (G) with washer and tighten using 3/16 inch hex key
d. Your sideguard (H) can now be inserted into the receiver.
NOTE– After installing the receiver hardware and inserting the side guard, check for interference. Don't
operate the wheelchair if the side guard interferes with any of the other components.
64
65
66
IX. DEALER SERVICE AND ADJUSTMENT
29
64
65
66
H
MK-100071 Rev. E