Replacing The Led Lights - JMA NEO Notice D'utilisation

cable.
2) unscrew the two rear legs (a) of the machine and remove them.
3) unscrew the four screws (25) that secure the lower protection plate (h) and remove it.
4) disconnect all of the connection plate wires (Z), noting the previous position of each
wire.
5) unscrew the four screws (26) that fasten the connection plate (Z) to the machine
structure and remove it.
6) to set up the new connection plate, perform the same operations in reverse order.
See figure 16
4.6

REPLACING THE LED LIGHTS

this operation is done as follows:
1) turn the machine off using the general switch and disconnect the power supply cable
2) loosen the "tracer adjustment locking screw" (9) and unscrew the "tracer height
adjustment wheel" (8) until it is removed.
3) unscrew the four screws (21) that secure the "Machine head guard" and remove it.
the screws are located on the front and back of the machine.
4) at the connection terminals, remove the two led strap wires, noting the previous
position of each wire.
note: to facilitate the understanding of step 1) to 4), see the figure in section 4.3
(tightening and replacing the belt).
5) remove the cutter (F) and tracer (P) from their corresponding tool supports.
6) remove the "tracer movement spring lever" (7).
7) unscrew the three screws (27) that fasten the burr protector (w) to the machine head
and remove it.
8) detach the led strap (l) and remove it.
9) to set up the new led strap, perform the same operations in reverse order.
See figure 17
5. SAFETY
For safety reasons, we recommend following these guidelines:
do not attempt to start or handle the machine until all issues regarding safety,
installation instructions, operating guides and maintenance procedures have been
fulfilled and understood.
always disconnect the power supply before performing any cleaning or maintenance
work.
always keep the machine clean, as well as its surrounding environment.
work with dry hands.
always use protective glasses even though the machine has protective elements.
ensure that the machine is earthed.
we recommend working with the machine at a height where the user is comfortable:
the highly recommended option is to work sitting down. adjust the height of the seat
until the eyes of the user are at the same height as the highest point of the machine.
if standing to work, depending on the height of the user, it is recommended that you
place a support between the table and the machine, such that the eyes of the user are
at the same height as the highest point of the machine.
6. REMOVAL OF WASTE
waste is understood to be any substance or object that derives from human activities
or natural cycles.
6.1 PACKAGING
as the packaging in which the neo is supplied is cardboard, it can be recycled as
packaging.
as waste, and considered solid urban waste, it can only be placed in special containers
for the recycling of cardboard.
the casing that protects the machine within the cardboard box is made of polymer
material comparable to solid urban waste. it cannot be eliminated in any other way than
through normal waste removal facilities.
6.2 BURRS
the waste produced in the duplication of keys is classified as special waste, but it is
classified as solid urban waste, for example, a metal scouring pad. this waste will be
removed according to the classification of current legislation in the eu, being delivered
to special waste removal facilities.
6.3 MACHINE
before destroying the machine, it must be out of service, which is done by cutting the
electric supply source and separating the plastic pieces from the metal pieces.
after doing this, all the waste may be eliminated in accordance with the current
legislation in the country where the machine is being used.
14
7. EXPLODED PLAN
See figure 18