Maintenance And Safety; Replacing The Belt; Replacing The Light; Replacing Fuses - JMA DAKAR Notice D'utilisation

4
Maintenance
and safety
When carrying out maintenance operations, the
following requirements must be met:
Never carry out maintenance operations with the
1
machine in operation.
Unplug the machine.
2
3 Strictly follow the indications in the manual.
4 Use original spare parts
4.1

Replacing the belt

To check the tightness of the belt or to replace, proceed
as follows:
Turn off the machine at the main switch and unplug it.
1
Undo the four screws securing the machine's rear
2
protection.
3
Undo the four screws holding the motor in place.
Tighten or replace the belt.
4
5 To tighten the belt, push the motor towards the rear
of the machine and tighten the four screws securing
the motor.
6 To replace the belt, carry out the same operations as
for tightening but with a new belt.

Replacing the light

4.2
To replace the light, proceed as follows:
Switch off the machine.
1
Release the fixing ring.
2
Remove the light and undo its wire.
3
Connect a new light to the wire, put it in its housing
4
and secure with the fixing ring.
4.3

Replacing fuses

If the machine does not start when switched on, check
the fuses:
To do this, proceed as follows:
1
Switch off and unplug the machine.
Remove the fuse-holder next to the main switch.
2
Check (using a tester) if a fuse has blown and, if so,
3
replace it with another identical one.
4.4

Safety recommendations

1 Do not try to start the machine or use it until all safety
aspects, installations instructions, operating guidelines
and maintenance procedures have been carried out and
understood.
2
Always unplug the machine before carrying out
maintenance or cleaning operations.
Always keep the machine and its surrounding area clean.
3
5
A series of accessories are available.

Basic accessories

5.1
The machine is supplied with a series of accessories for
its use and maintenance:
Two fuses, two 3 and 2.5 Allen keys, two plates for end
See figure 23
stop, two F-1 / F-13 milling cutters and two P-1 / P-13
tracer points.
5.2 List of accessories for cutting certain
models of key
List of accessories:
Milling cutters and tracer points to be used to cut the
following keys:
See figure 24

Accessories

See figure 25
13