Publicité
Les langues disponibles
Les langues disponibles
Date
Date And Time
Date Format
Time
Entry Delay <000S>
Entry Exit Delay
Exit Delay <000S>
Backlight Time
<00S>
Auto Arm Time
<00:00:00>
Auto Arm/
Disarm
Auto Disarm Time
<00:00:00>
Edit Welcome
Control by
On
Phone
O
On
Linecut Alarm
O
On
Keypad Tones
O
Admin Code
User Code
Access Code
System
Settings
Duress Code
Ringing Times
Record
Alarm Voice
Play
Wired Siren
Wireless Siren
Siren Setup
Built-in Siren
Siren Alert Time
<300S>
Input 4 Digits
User ID<1234>
On
Arm Upload
O
On
Disarm Upload
O
Reset
History
11
All manuals and user guides at all-guides.com
Input 6 Digits
<Default Code 123456>
Input 4 Digits
<Default Code 1234>
Input 4 Digits
<Default Code 1111>
Siren Switch <On/O >
Arm/Disarm Tone <On/O >
Siren Switch <On/O >
Arm/Disarm Tone <On/O >
Siren Switch <On/O >
Arm/Disarm Tone <On/O >
Settings
When LCD is activated, input the admin code, and then press
menu.
1. Alarm Phone Number Setup
User can set 6 user phone numbers and 2 CMS phone numbers. When connecting to
1
CMS, system will dial CMS phone number to upload Contact ID reports while alarming
2
and then dial 6 user phone numbers in sequence one by one. System will dial all the user
3
phone numbers in 3 cycles until the phone is answered or any press on phone buttons.
4
Add Alarm Phone Number
Log on the menu, choose "Phone Numbers", press
Press
[ ]
or
[ ]
, choose "Add Phone Number", press
Press
[ ]
or
[ ]
, choose "Alarm Number1~6", press
Input alarm phone numbers in order, press
used, 0# or 9# need to be added in front of the phone number.
Note!
If user want to check or edit the stored phone number, enter "Alarm Number1~6"to
check and edit.
Delete Alarm Phone Number
Log on the menu, choose "Phone Numbers", press
1
Press
[ ]
or
[ ]
, choose "Delete Phone Number", press
2
Press
[ ]
or
[ ]
, choose "Alarm Number1~6", press
3
Delete the alarm phone numbers in order, press
4
Note!
If user wants to set CMS center phone number, please refer to "Connect to CMS Center".
2. Add/Delete/Edit Accessories
The control panel only receives signal from accessories after they are connected to the
control panel.
Add/Delete Remote Controls or Wireless Keypads
Add
Log on the menu, press
[ ]
or
[ ]
, choose "Accessories", press
1
Press
[ ]
or
[ ]
, choose "Remote & Keypad", press
2
Press
[ ]
or
[ ]
, choose "Add", press
[Enter]
3
LCD display will show "Please connect", press any button from the remote control to
4
enable signal transmitting to the control panel. When a beep is heard, LCD display will
show "Remote (01-10)", connection succeeded.
[Enter]
to enter setting
[Enter]
.
[Enter]
.
[Enter]
.
[Enter]
. If group extended telephone number is
[Enter]
.
[Enter]
.
[Enter]
.
[Enter]
again
[Enter]
.
[Enter]
.
.
12
Publicité
