Publicité
Les langues disponibles
Les langues disponibles
Usage
Remove the battery activation strip to activate batteries. It will start self-testing
for one minute.
Mode Setting
Test Button
Testing mode:
After self-testing, press the test button, the sensor enters testing mode, and
detects once every 10 seconds. After 3 minutes, the LED ashes twice, and the
sensor enters the working mode.
Working mode:
In working state, if the sensor is triggered twice within 3 minutes, it will enter
sleeping mode to save power. After no movement within next 3 minutes, the
sensor goes back to the working mode.
Connect to alarm panel
Press the connect key on the alarm panel, and then press the test button of the
sensor twice to send alarm signal. When one beep is heard, they are connected. To
check if they are connected successfully, arm the system, and trigger the sensor
again, if there is an alert, the connection is successful.
Installation & Notices
Avoid mounting the detector close to windows, air conditioner, heater, refrigerator,
oven, sunshine and places where the temperature changes fast or the air stream ows
frequently.
If two detectors are installed in the same detection scope, please adjust the locatio to
avoid interference and false alarm.
2m
Ground
Top view
Fix the bracket on the wall with screws and attach the detector to the bracket.
Adjust installation height or bracket to change the detection distance and
angle. It is recommended to mount it at the height of 2m from the ground.
The detector is more sensitive to the cross movement than to the vertical
movement, so th e per forma n ce of de tec to r is best wh e n th e de tec tion
direction is vertical to the walking direction of people.
Testing (Walk Test)
A. After installation, power on the detector. After one minute self-testing, press the
test button, walk in the scope (from left to right or from right to left) and watch the
LED indicator to make sure the detector is working.
B. The LED indicator ashes once when body movement is detected.
C. Adjust the detector angle accordingly to achieve the best detection e ect.
29
All manuals and user guides at all-guides.com
Side view
Detection Scope
110°
Top view
Speci cations
Power supply
DC 3V (AA 1.5V LR6 Battery x 2 pcs)
Static current
≤ 50uA
Alarm current
≤ 9.5mA
Detection scope
8m/110°
Transmitting distance
≤ 80m (in open area)
Standards
This
product
bears
the
selective
equipment(WEEE).This means that this product must be handled pursuant to European.
2002/96/EC in order to be recycled or dismantled to minimize its impact on the environment.
For further information,please contact your local or regional authorities.
Electronic products not included in the selective sorting process are potentially dangerous for
the environment and human heath due to the presence of hazardous substances.
In compliance with European's law.
This product was designed and manufactured in compliance with Directive 2002/95/EC of the
European Parliament and of the Council on the restriction of use of certain hazardous substances in
electrical and electronic equipment (RoHS Directive - Rohs) and is deemed to comply with the
maximum concentration values set by the European Technical Adaptation Committee(TAC).
0m
2m
4m
6m
8m
2m
0m
Side view
Radio frequency
315MHz or 433MHz (± 75KHz)
Housing material
ABS plastic
Operation Condition
Temperature: -10°C~55°C
Humidity: ≤80%RH (non-condensing)
Detector dimensions (L x W x H)
108 x 52 x 36.8 mm
Bracket dimensions (L x W x H)
52 x 30 x 26.5 mm
sorting
symbol
for
waste electrical
and
electronic
Directive
30
Publicité
