Publicité
Les langues disponibles
Les langues disponibles
Control Panel Operation
1. Alarm Control
Arm (Away Arm)
Press the
the system enters Arm state when one beep is
heard and the Arm LED Indicator lights on.
Note!
If Entry/Exit Delay is activated, all zones except the
24-hour zone will enter Arm state after the set delay
time.The Delay Sensors will enter Arm state after the
set delay time.
Home Mode (Part Arm)
Press the
control panel, the system enters Home Mode when
one beep is heard and the Home Mode LED
Indicator lights on. All the Normal Sensors are
armed except the Home Mode Sensors which
are disarmed so that users can move freely at home.
Disarm
Input user code or admin code
the
[Disarm
state when one beep is heard and the Disarm LED
Indicator lights on.
Emergency Call
Hold the
display is activated, the system goes into emergent
alarming state with siren hooting, meanwhile the
Panel will auto dial pre-stored alarm phone numbers.
7
All manuals and user guides at all-guides.com
[Arm
]
button on the control panel,
[Home Mode
]
button on the
rst, then press
]
button, the system enters Disarm
[
]
button for 3 seconds when the LCD
2. Access Control System
The control panel has a RFID reader for unlocking the electronic door lock
by disarming the system. Just place the RFID tag close to the RFID reader,
the green LED indicator ashes once.
The system is disarmed and the electronic door lock is open (If
connected).
3. Dialing Calls
The control panel has a built-in call module. Make sure the PSTN land line
is connected and the credit is enough, you can use the panel to make calls.
When the control panel is in Disarm or Home Mode state, input the phone
number and press
[Call
]
button, the line will get through. If you input
wrong numbers, press
[Esc]
button and input again. Press
cancel dialing or press
[Call
]
button to end a conversation.
4. Voice Memo
Hold 3 seconds
[
]
button to record 10 seconds voice message. The
Play Voice Memo circle will be ashing in blue to notify you. Users can
touch the center of circle to listen to the voice memo. The LED indicator
blacks out when the voice memo has been played. Replay by touching it
again.
5. Function Setting
Input the admin code, and then press
[Enter]
Up
Enter
Con rm
Down
B
c a
t k
l o
s a
s t
e t
Esc
[Esc]
button to
to enter setting menu.
p
8
Publicité
