eTIGER TL SECUAL Mode D'emploi page 4

Rear Side
MIC
PSTN Land Line Interface
Interfaces for
Wired Sensors
Output Wired Siren
( 500mA) ≤
Output for Electronic
Lock
NC Input for
Wired Sensor
(24H Zone)
NC Input for
Wired Sensor
(Normal Zone)
5
All manuals and user guides at all-guides.com
Buzzer
Tamper Switch Speaker
Power ON/OFF
AC Adapter Interface
Backup Batteries
Preparation before Use
1. Power on
Plug the output connector of AC adapter
1
into the adapter interface of control panel.
Plug the AC adapter to wall power socket.
2
Turn the power switch from OFF to ON.
3
2. Connect PSTN Land Line
S2 is a PSTN alarm system which will auto dial the
pre-stored phone number when the system
detects intruders.
Please make sure the panel has been
connected to PSTN land line to ensure safety.
Connect the smaller connector of provided telephone cable to the PSTN land line
1
interface at the back side of the pane.
Connect the other end of the telephone cable to the signal output
2
provided by PSTN land line operator.
3. Installation
1) Wall Mounting
Fix the wall mounting bracket on the wall with screws. Wedge the panel on the
bracket, make sure they t well.
2) Standing on the Desk
Mount the desktop bracket, and then put it on the desk.
2
3
1
2
1
6