Publicité
Les langues disponibles
Les langues disponibles
Using your P35 power amplifier
POWER (AND POWER INDICATOR LIGHT)
Switches the unit on and off. The light indicates the status of the
amplifier.
When you switch your amplifier on, the light glows amber for a few
seconds, during which time the speakers are disconnected. The light
changes to green when the amplifier is ready for use. A red light
means the amplifier is in standby mode.
The light may flash if a fault has occurred. You should unplug the
amplifier and leave it for a few minutes before reconnecting. If the
fault cannot be cleared, unplug your amplifier and contact your Arcam
dealer.
All manuals and user guides at all-guides.com
12
SP1 AND SP2
These buttons allow you to select and deselect the main (
secondary (
) sets of speakers attached to your amplifier. An
SP2
indicator light shows which set of speakers are currently selected.
NOTE: If both lights are out the amplifier will appear not to work,
as all speakers are switched off. If both are on, and low impedance
speakers are connected, overloads are more likely.
P35 POWER AMPLIFIER
SP1
SP2
POWER
) and
SP1
Publicité
