Barbecook SIESTA 310 BLACK EDITION Mode D'emploi page 9

7.5 To check for gas leaks
You check for gas leaks by applying a testing liquid to all gas
components and connections. lf the bubbles on a particular
component or connection grow, there is gas leak:
To check for gas leaks, proceed as follows:
1. Put the appliance outside.
2. Get your leak test tool and testing liquid (leak spray or
water/soap mixture).
3. Open the lid and set all control knobs to OFF.
4. Open the gas supply slightly. Turn the valve of the gas
cylinder only once.
5. Suck up some testing liquid with the leak test tool and apply
it to the area that you want to check. You have to check:
• The welds of the gas cylinder (A)
• The hose (B)
• The connections between the cylinder and the pressure
regulator and between the pressure regulator and the
hose (C)
• The connection between the hose and the appliance (D)
Your pressure regulator and coupling may be different
from the ones in the illustrations.
6. Do one of the following:
• If you detect a leak, continue as described in "In case of
a gas leak".
• If there are no leaks, close the gas supply, rinse all
components thoroughly with water and dry them well.
All manuals and user guides at all-guides.com
7.6 In case of a gas leak
1.
2.
3.
8
8.1 Before each use
Each time you use the appliance, make sure that:
•
•
•
•
•
8.2 Before first use (in a long time)
lf you use the appliance for the first time or for the first time
after a long period of non-use, you have to execute some extra
checks:
•
•
•
•
www.barbecook.com
Close the gas supply and do one of the following:
• If you detected a leak on one of the connections, tighten
that connection.
• If you detected a leak on the cylinder or hose, replace
the cylinder or hose.
Recheck the connection or component on which you
detected the leak.
If the leak is not repaired, contact a Barbecook dealer. Do
not use the appliance until the leak is repaired.
For a list of nearby Barbecook dealers, refer to
www.barbecook.com.
GETTING THE APPLIANCE READY
FOR USE
The appliance is in an appropriate location. See "3.3 Select
an appropriate location".
The gas hose does not drag on the ground and cannot
come into contact with a hot surface or with dripping fat.
The bowl is clean. We recommend cleaning the bowl after
each use. See "11.2 Cleaning the bowl".
The burners and venturis are not blocked by insect nests or
spider webs. See "11.3 Cleaning the burners and venturis".
The burners are assembled correctly. The venturis have to
be placed over the openings of the gas valves.
lf you want to be absolutely sure that your gas connection
is okay, you can check your appliance on gas leaks
before each use. See "7 Checking for gas leaks".
Make sure that you have read, understood and checked all
the instructions in this manual (only before first use).
Check the appliance for gas leaks. See "7 Checking for gas
leaks".
Also check for gas leaks if your appliance was assembled
by your dealer.
Clean the burners and venturis (only before first use in a
long time) . See "11.3 Cleaning the burners and venturis".
Burn in the appliance before you put any food on it (only
before first use). See "8.3 Burning in the appliance".
9