Barbecook SIESTA 310 BLACK EDITION Mode D'emploi page 13

11.3.3 t
o clean the bUrners and ventUris
1. Remove the burners from the appliance as shown on the
illustrations. lf you notice that a burner is damaged, you
have to replace it.
2. Clean the burners and venturis with a small brush or a
homemade pipe cleaner (an unfolded paperclip, a pipe
brush ... ).
3. Put the burners back. Make sure to place the venturis over
the openings of the gas valves.
A
B
All manuals and user guides at all-guides.com
11.4 Maintaining enamel, stainless steel,
The appliance is composed of enamelled, stainless steel,
chromed and powder coated parts. Each material has to be
maintained differently:
Below the exploded view of your appliance (second part of the
manual), you find a list with all parts of which the appliance
is composed. This list includes a symbol that specifies the
material of each part, so you can use it to check how you have
to maintain a particular part. The parts list uses the following
symbols:
www.barbecook.com
chrome and powder coated parts
Material
Enamel •
•
•
Stainless steel
•
and chrome
•
•
•
•
Powder coated
•
To prevent formation of rust on stainless steel, avoid
contact with chlorine, salt and iron. We recommend not
using the appliance near the coast, near railways or near
swimming pools.
Damages caused by not following these instructions are
regarded as inadequate maintenance and are not covered
by the warranty.
Symbol
Enamel
Chrome
Stainless steel
Powder coated
How to maintain this material
Do not use sharp objects and do
not knock against a hard surface.
Avoid contact with cold liquids
while still hot.
You can use metal sponges and
abrasive detergents.
Do not use aggressive, abrasive or
metal detergents.
Use soft detergents and let them
act on the steel.
Use a soft sponge or cloth.
Rinse thoroughly after cleaning
and dry well before storing.
Do not use sharp objects. Use soft
detergents and a soft sponge or
cloth.
Rinse thoroughly after cleaning
and dry well before storing.
Material
13