Caliber MCD 893 Manuel page 25

All manuals and user guides at all-guides.com
Symbol Type
Section
These speed cameras work in pairs, and do not measure your current
control
speed but your average speed between the two speed cameras. Both
identify your car and record the exact time you pass them. They use the
difference between the two points in time to calculate your average
speed.
MCD893 warns you when you approach one of these speed cameras,
but as you pass by, the warning stays on, and your average speed is
measured until you reach another speed camera of this type. If your
average speed exceeds the speed limit between the two speed
cameras, you receive the same special warning sound as with the other
speed camera types.
In the rare case MCD893 cannot register the moment you pass the
second speed camera (for example, it is placed at the exit of a tunnel
where GPS position is not yet available) the warning continues. Just tap
the speed camera symbol displayed on the screen to stop the warning.
Red
These cameras check if you obey traffic lights. The warning is similar to
light
mobile speed cameras: as there is no speed limit given, only the
proximity is announced.
2.5.10.2 Camera directions
A speed camera can measure the speed of one direction of the traffic, both directions, or
even several directions in an intersection, when they are mounted on a rotating base. The
same directions apply to red light cameras. MCD893 warns you only if you drive in a
measured or possibly measured direction. The measured direction of the camera appears
with the following symbols:
Symbol
The camera checks the speed of the direction into which you are driving.
The camera checks the speed of the opposite driving direction.
The camera checks the speed in both directions on the road.
The camera can check the speed in any direction.
2.5.11 Speed limit warning
Maps sometimes contain information about the speed limits of the road segments. This
information may not be available for your region (ask your local dealer) or may not be fully
correct for all roads on the map.
You can configure MCD893 to warn you if you exceed the current limit. Tap the following
buttons: , ,
When you exceed the speed limit, the following happens:
24
Description
Description
, .