Publicité
Les langues disponibles
Les langues disponibles
Instruction manual
INSTALLATION
•
Warning: leave this mobile air-conditioner in an upright position for at
least 2 hours before first use.
•
This air-conditioner may be moved indoor conveniently; leave the air-
conditioner in an upright position while moving it. The air-conditioner
shall be placed on a flat ground surface. Do not install or operate this
air-conditioner in a bathroom or other wet environments.
ASSEMBLY
Heat exhausts hose
•
Heat exhausts outer connector (Figure 1A)
•
Heat exhaust hose short connector (Figure 2A)
•
Heat exhausts outer connector (Figure 1)
•
Take out the two pieces of the heat exhaust hose outer connector,
these two pieces are the same in structure.
•
Hold one piece with each hand, put the joint of one piece toward the other
one's groove, and press them to make them snap tightly (Figure 1A).
•
Take out the heat exhaust hose both connectors, screw both
connectors into the heat exhaust hose (Figure 1 + 2A).
Installation of the C shape buckle of the heat exhaust hose
Place the rotatory hole of the C shape buckle over the rotation shaft on the
back of the unit (as shown in Figure 3).
Installation of the heat exhaust hose
•
Lift up the C shape buckle with one hand and place with your other
hand the short connector of the heat exhaust hose in de recess on the
back of the unit. (as shown in Figure 5).
•
Lock exhaust hose firmly by pushing the C shape buckle downwards
until it clicks. (as shown in Figure 5).
6
All manuals and user guides at all-guides.com
Installation of the window sealing board assembly
•
Open the window and mount the window sealing board assembly
onto the window, either vertically or horizontally (as shown in Figure 7
and 8).
•
Pull apart the parts of the window sealing board assembly, adjust the
distance of the assembly so the two ends of the assembly will come into
contact with the window frame, fasten the parts of the assembly with
copper screws.
Installation of the unit
•
Make sure the unit is placed with at least 50cm away between the walls
or other objects. (As shown in Figure 9).
•
Snap the flat end of the heat exhaust hose into the elliptical hole of the
window sealing board assembly (as shown in Figure 10and 11).
Important notes
•
The exhaust hose is 280mm-1500mm long and this length is
determined based on the specification of the air-conditioner (s). Do not
use prolonged hose or replace with other different hoses as this may
affect the functions of the air-conditioner. The exhaust must be smooth
and the air-conditioner may overheat if the exhaust is obstructed.
•
The heat exhaust hose may not be bent and shall be free from
significant (greater than 45°) flexure, the heat exhaust hose shall be
ventilated properly.
Publicité
