Husqvarna T525 Manuel D'utilisation page 3

19. Belt eyelet
20. Clutch cover
21. Chain tensioning screw
22. Product and serial number plate
23. Chain catcher
24. Oil pump adjustment screw
25. Bar nut
26. Transportation guard
27. Operator's manual
28. Combination wrench
29. Vibration damping system, 3 units
30. Spark plug
31. Spark plug cap
32. Muffler
33. Air filter
34. Brake band
35. Chain adjuster pin
36. Muffler cover
Symbols on the product
Be careful and use the product correctly.
This product can cause serious injury or
death to the operator or others.
Read the operator's manual carefully
and make sure that you understand the
instructions before you use this product.
Always wear approved protective helmet,
approved hearing protection and eye
protection.
Chain brake, engaged (right). Chain
brake, disengaged (left).
Air purge bulb.
Adjustment of the oil pump.
Fuel.
Chain oil.
2342 - 001 - 10.11.2023
Both of the operator's hands must be used
to operate the chainsaw.
Never operate the chainsaw holding it with
one hand only.
Never let the guide bar tip come in contact
with any object.
Warning! Kickback may occur when the
nose or tip of the guide bar touches an
object, and cause a lightning fast reverse
reaction, kicking the guide bar up and
towards the operator. May cause serious
personal injury.
XX
Computed kickback bar stopping angle
without actuated chainbrake, CKA wob.
XX
Computed kickback bar stopping angle
with actuated chainbrake, CKA wb.
Husqvarna H37
16
Max 9T
yyyywwxxxxx
Note:
Other symbols/decals on the product refer to
certification requirements for some markets.
Recommended cutting
equipment in this exam-
ple: Guide bar length 16
in, maximum nose radius
9 Teeth and chain type
Husqvarna H37.
Work position.
Choke.
The rating plate shows se-
rial number. yyyy is the
production year and ww is
the production week.
3