Weber Summit E-620 Guide De L'utilisateur page 18

USING THE SMOKER
The smoker uses presoaked wood chips. For best results with faster cooking foods like
steaks, burgers and chops, etc., we recommend using finer wood chips because they
ignite and create smoke faster. For longer cooking foods such as roasts, chicken and
turkeys, etc., we recommend using larger wood chunks because they ignite slowly and
provide smoke for a longer period of time. As you gain experience in using your smoker,
we encourage you to experiment with different combinations of wood chips and chunks
to find the smoke flavor that best suits your taste.
TO USE THE SMOKER
As a starting point, soak wood chips in water for at least 30 minutes before using. (Wet
wood will produce more smoke flavor.) Place a handful of wood chips or a few larger
chunks in the bottom of the smoker body (1). As you gain experience in smoking,
increase or decrease the amount of wood to suit your taste.
Note: Always grill with the lid closed to allow the smoke to fully penetrate the food.
Light the smoker burner by following the instructions for Lighting The Smoker Burner
After wood starts to smolder turn control knob to "LOW".
Smoke will start in approximately 10 minutes and last as long as 45 minutes. If you
require more smoke flavor, refill the smoker with wood chips and/or chunks. Keep the
lid of the grill closed while cooking.
Note: After refilling smoker, smoke will take about 10 to 15 minutes to start again.
The smoker may be used to enhance meat, poultry and fish recipes. Cook with the lid
down according to the times indicated in charts or recipes.
DANGER
Do not use any flammable fluid in the smoker to ignite the
wood. This will cause serious bodily injury.
(1)
CLEANING THE SMOKER
Before each use, empty the smoker of ash to allow proper air flow.
Note: Smoking will leave a "smoke" residue on the surface of the smoker. This residue
cannot be removed and will not affect the function of the smoker. To a lesser degree a
"smoke" residue will accumulate on the inside of your gas grill. This residue need not
be removed and will not adversely affect the function of your gas grill.
LIGHTING THE SMOKER BURNER
DANGER
Failure to open the lid while igniting the grill, or not waiting
5 minutes to allow the gas to clear if the grill does not light,
may result in an explosive flare=up which can cause serious
bodily injury or death.
SMOKER BURNER SNAPIGNmON
Note. The control knob snap igniter creates a spark from the igniter electrode to the
burner lighting tube. You generate the energy for the spark by pushing in the control
knob and turning to "START/HI". This will ignite the smoker burner.
WARNING: Check hose before each use of grill for nicks,
cracking, abrasions or cuts. if the hose is found to be
damaged in any way, do not use the grill. Replace using only
®
Weber authorized replacement hose. Contact the Customer
Service Representative in your area using the contact
information on our web site. Log onto www.weber.com ®.
1) Open the grill lid.
2) Open smoker box lid.
3) Fill smoker with water soaked wood chunks or chips.
4) Make sure that all burner control knobs not being used are turned to "OFF". (Push
control knob in and turn clockwise to ensure that it is in the "OFF" position).
5) Turn on the gas at source.
z_ WARNING: Do not lean over the open grill while lighting.
6) Push the control knob in and turn to "START/HI" until you hear the igniter snap -
continue to hold control knob in for two seconds. This action will spark the igniter,
the burner lighting tube and then main burner.
7) Check that the burner is lit by looking through the cooking grates. You should see
a flame. If burner does not light on first try, push control knob in and turn to OFF.
Repeat lighting procedure a second time
®
®
*The grill illustrated may have slight
differences than the model purchased.
®
® ®
DANGER
If the smoker burner does not light, turn the burner control
knob to "OFF" and wait 5 minutes to let the gas clear before
attempting to light.
8) Close smoker cover after wood starts to smolder and turn control knob to "LOW".
TO EXTINGUISH
Push in and turn each burner control knob clockwise to "OFF" position. Turn gas supply
off at the source.