2 Before cleaning
2
Before cleaning
2.1 Unpacking
Unpack the appliance and all accessory parts
and check that the contents are in perfect
condition and complete (fig. 2).
ATTENTION:
Always transport/send the appliance in its
original
packaging
damages. Keep the packaging for such an
event.
Dispose of no longer needed packaging
material
according
regulations of your country.
NOTE:
Immediately contact your dealer if you have
found damage resulting from transport.
2.2 Assembly
1. Assemble the handle by connecting the
upper part with the handle (fig. 2/3) to the
bottom part (fig. 2/2) The release catch
(fig. 2) clicks into place noticeably.
2. Insert the now assembled handle into the
pump joint. The release catch (fig. 2)
clicks into place noticeably.
NOTE:
If you want to remove the handle again,
press the release catch (fig. 2A) and pull
the handle up and out.
3. Lay a micro-fibre cleaning cloth (fig. 2/7)
on the floor (Velcro strips topside) base
and place the steam base on top. The
cleaning cloth is held by Velcro strips.
Only on carpets:
4. Place the optional carpet glider plate
(fig. 2/8) under the steam foot (fig. 1/10)
with the attached cleaning cloth (fig. 2/7).
to
avoid
transport
to
the
applicable
2.3 Filling the water tank
1. Make sure that the power cable has been
disconnected from the plug socket.
WARNING:
Danger of electric shock! Never fill an
appliance with water when it is connected
to the mains.
2. Twist the filler cap counter-clockwise off
the water tank.
3. Place the included filling funnel (fig. 2/4)
into the filler opening of the water tank.
WARNING:
Danger of injury! Use no additives such as
cleansers, alcohol, perfumes or chemicals
in your water. These make the use of the
appliance unsafe.
4. Fill the included filling-container (fig. 2/5)
up to the "MAX" mark with clear, cold tap
water.
5. Fill the water tank using the filling-funnel
and the filling-container (fig. 3). Be aware
of any residual water in the tank. There is
a risk of spilling water or overfilling the
water tank. Do not use any other
containers for refilling. The capacity of the
filing-container exactly suits that of the
water tank.
NOTE:
The service life of the appliance can be
extended by using distilled water instead of
tap water. This is especially recommended
in areas with hard water.
6. Close the tank cap by inserting it so that
the
mark on the cap matches the
mark on the tank. Then twist the cap
clockwise by approx. 180° and check it for
tight fit.
17