Before Use - Dirt Devil vaporex M380 Mode D'emploi

3 Before use

3.3 Assembly
6
A
B
7
A
B
8
A
C D
F
9
90°
A B
C
C
B
E
G
Attaching accessory adapter and pinpoint nozzle:
NOTE:
The accessory adapter must be fitted before attaching the pinpoint noz-
zle. The accessory adapter may be attached directly to the steam pistol
or, if necessary, to one of the extension tubes. You may use the pinpoint
jet nozzle to clean hard-to-reach places like grooves, venetian blinds,
toilet bowls, bathroom fixtures, etc.
1. Push the accessory adapter all the way onto the connecting tube as
shown (Fig. 6/A). You will feel and hear it snap into place.
NOTE:
To release the accessory adapter, push the release latch on the steam
pistol.
2. Fit the pinpoint jet nozzle to the accessory adapter so that the arrow
markings on either part correspond (Fig. 6/B).
3. Fasten the pinpoint jet nozzle by turning it in the direction of the arrow
(Fig. 6/B).
Attaching further accessories:
NOTE:
All other supplied nozzles and brushes (except the floor nozzle) must be
fitted to the pinpoint jet nozzle.
1. Push the desired attachment onto the pinpoint jet nozzle:
- use the jet nozzle (Fig. 7/A), for applications similar to those of the
pinpoint jet nozzle, but requiring an even finer steam jet;
- use the plastic brush (Fig. 7/B) to remove stubborn dirt that cannot
be dissolved by steam power alone;
- use the wire brush (Fig. 7/C) to remove stubborn dirt from very hard-
wearing surfaces;
- use the 2-in-1-combi attachment (Fig. 8/A) to steam-clean smooth
polished surfaces;
- use the 2in1 combi attachment's steam base (Fig. 8/B) refreshing
clothing or draperies;
- use the steam base with cotton cover (Fig. 8/C) for steam-cleaning
carpets and upholstery while simultaneously picking up the dissolved
dirt.
Attaching extension tubes and floor nozzle:
1. Stick the connecting-piece into the floor nozzle as shown (Fig. 9/A).
2. Lock it by turning it by 180° (Fig. 9/B).
3. If necessary, attach a floor cloth under the clips provided on the floor
nozzle (Fig. 9/C,D,E).
4. Push an extension tube all the way onto the connecting tube as shown
(Fig. 9/F). You will feel and hear it snap into place.
5. If necessary, stick another extension tube all the way onto the extension
tube you just attached. You will feel and hear it snap into place (Fig. 9/
G).
6. Now stick the floor nozzle with the connecting-piece all the way onto the
attached extension tube (Fig. 9/H). You will feel and hear the connect-
ing piece snap into place.
H
19