Publicité
Les langues disponibles
Les langues disponibles
INSTALLATION
Measure the distance between the cooking element
and the bottom of the range hood. A distance of 28"
to 30" is recommended*.
*
Due to different ceiling height configurations, the
recommended height may not be applicable
Step 1: You have two options for installing this range hood (see INSTALLATION DIAGRAMS on page 22). Determine
the venting method and proceed as follows:
1.
Using references in the Height & Clearance diagram, determine and clearly mark the centerline
on the bottom of the cabinet.
2.
Draw electrical wires through cabinet access opening on top or back of the range hood, center
the hood beneath the cabinet and flush with the front of the cabinet.
3.
From the inside of the hood, place hood mounting screws in the exact center of each knockout
holes and secure to the cabinet bottom. Tighten all screws until secure. Be careful when using
electrical screwdriver in order not to damage the range hood. If venting is to be done vertically,
connect and secure the 6'' round metal duct (refer to figure 1).
Step 2:
For safety purpose, pre‐drilled mounting holes are provided through the back of the hood. For a more secure
installation, use as many mounting holes as needed to secure the hood from the inside.
In the case of vertical evacuation use a 6" round metal pipe (as in figure 1) to connect the exhaust on the hood to
the ductwork. Use duct tape to make all joints secure and air tight.
Step 3:
Turn power ON in control panel. Check all lights and fan operations.
.
CAUTION: Make certain the range hood is secure before releasing!
1
Figure
27
Publicité
