medi Arm Butler Mode D'emploi page 5

cloth, rubberised sheet etc.)
Feed the sleeve onto the
semicircular cylinder.
Please note that the seam is
positioned slightly offset to the
dead centre of the side (Fig. 3).
Sleeves for the left arm - slightly
to the outer left (at approx. 8
o'clock).
Sleeves for the right arm -
slightly to the outer right (at
approx. 4 o'clock).
Now lie the medi Arm Butler flat
on the table.
The bracket stabilises this
donning aid on the edge of the
table.
Insert your arm into the sleeve,
keeping the angle the same and
without turning it (Figs. 5 and 6).
Check that the sleeve is
positioned correctly again (the
position of the back seam, upper
fastening, crook of arm etc.) and
pull up the top band or the
fastening if required (Fig. 7).
Tip: The medi fabric gloves and
rubber gloves enable you to
arrange and position
compressive aids on arms and
legs correctly.
Cleaning the medi Arm Butler
If desired, you can clean your
donning aid with the standard
commercially available
disinfectants or detergents.
Please wipe down the frame and
make sure that no liquid gets into
the hollow part of the base (5).
Material composition
Steel
Finishing: powder-coated, white,
glossy
Disposal
Please dispose of the medi
donning aid correctly at the
respective collection point for
scrap metal.
There are no specific criteria for
disposal as hazardous waste.
English