GCE HEALTHCARE OC Serie Notice D'utilisation page 8

8. When you are not using the oxygen concentrator, press the power switch to the O [O]
position to turn o the power.
OPERATION MODES AND LCD DISPLAY GUIDE
MODE
Start within
EN
5 minutes
Continuous
operation
Timed setting Set the length of your treat-
3. CLEANING, MAINTENANCE AND SERVICING
Always press the power switch to the O [O] position and unplug your OC Series Oxy-
gen Concentrator before cleaning.
The exterior of your oxygen concentrator should be cleaned weekly using a damp cloth
with a mild household cleaner. Always wipe the exterior dry after cleaning.
Your cannula and humidifi er must be cleaned and replaced as instructed by the manufac-
turer or your home oxygen provider.
You must clean the air fi lter in the OC Series Oxygen Concentrator at least once a week.
1. Open the access panel to the air fi lter to the side of the oxygen concentrator
2. Remove the air fi lters from the device
3. Rinse and allow to dry naturally
4. Once dry, reinstall the air fi lters
Maintenance and Servicing
The device has no user-serviceable parts, and must only be serviced by an authorized
provider.
GUIDANCE
In the fi rst fi ve minutes of
operation, the oxygen purity
indicator, hour, minute and
separator fl icker at the same
time.
The LCD indicates elapsed
time and current run time.
ment by pressing the up
and down buttons on the
button board to increase
or decrease the duration in
10-minute increments.
20 seconds after setting
your treatment duration,
the timer will automatically
begin to count down to the
end of your treatment. The
oxygen fl ow will stop once
the timer runs out.
LCD DISPLAY
Model OC-S has no oxygen indicator
8/167
Model OC-E