Pixsys ATR224 Manuel Utilisateur page 28

GROUP M -
d. i . 1
231 d. i . 1 .f. Digital Input 1 Function
Digital input functioning.
Disabled (Default)
diSab.
2 Setpoints Switch
2t. sw.
Run
rUn
Performing manual tune
tune
Automatic / Manual Impulse (if enabled on parameter 48 or 67)
au.ma.i.
Automatic / Manual Contact (if enabled on parameter 48 or 67)
au.ma.c.
Action Type. Cooling regulat. if D.I. is active, otherwise heating reg.
act.tY.
Manual reset. Reset the outputs if selected as manual reset.
M. reS.
232 d. i . 1 .c. Digital Input 1 Contact
Defines the resting contact of the digital input .
№rmally open (Default)
n.open
№rmally closed
n.cLos.
235÷238 Reserved Parameters - Group M
Reserved parameters - Group M
GROUP Q -
sft.s
264 SS.TY. Soft-Start Type
Enables and selects the soft-start type
Disabled (Default)
diSab.
Gradient
Grad.
Percentage (only with pre-programmed cycle disabled)
Perc.
266 SS.Gr. Soft-Start Gradient
Rising/falling gradient for soft-start and pre-programmed cycle.
.. Digit/hour
267 SS.Pe. Soft-Start Percentage
Output percentage during soft-start function.
.. %. (Default:
268 SS.tH. Soft-Start Threshold
Threshold under which the soft-start percentage function is activated, at starting.
- ... [digit
269 SS.ti. Soft-Start Time
Max. Softstart duration: if the processs will not reach the threshold selected on par. SS.tH. within
the selected time, the controller starts to regulate on setpoint.
Disabled
00:00
00:01-24:00
28 - ATR224 - DRR224 - User manual
- Digital input 1
- Soft-start and mini cycle
(degrees.tenths/hour if temperature). (Default:
p.
%)
] (degrees.tenths for temp. sensors) (Default:
p.
hh:mm (Default: 00:15)
. )
)