Publicité
Les langues disponibles
Les langues disponibles
148 A.2.u.L.
Alarm 2 Upper Limit
Upper limit selectable for the alarm setpoint
-
..+
149 a.2.re.
Alarm 2 Reset
Alarm contact reset type (always automatic if
Automatic reset (Default)
A. rEs.
Manual reset (manual reset by keyboard or by digital input)
M. rEs.
Stored manual reset (keeps the output status also after a power failure)
M.rEs.S.
Automatic reset with timed activation. The alarm remains active for the time set on the
A. rEs.t.
parameter 152
again, the alarm conditions must disappear.
150 A.2.S.e.
Alarm 2 State Error
Alarm output status in case of error
If the alarm output is relay
Contact or open valve. Default
open
Contact or closed valve.
CLose
If the alarm output is digital (SSR):
Digital output OFF. Default
off
Digital output ON.
on
151 A.2.Ld.
Alarm 2 Led
Defines the status of the led
ON with open contact or DO switched off.
o.c.
ON with closed contact or DO switched on. (Default)
c.c.
152 a.2.de.
Alarm 2 Delay
Alarm Delay. -
Negative value: delay when exit alarm status.
Positive value: delay when enter alarm status
153 A.2.S.p.
Alarm 2 Setpoint Protection
Allows or not to change the alarm setpoint
Editable by the user (Default)
FrEE
Protected
Lock
Protected and not visualized
HidE
154 A.2.Lb.
Alarm 2 Label
Selects the message displayed in case of alarm intervention.
Disabled. (Default) 0.
disab.
Message 1 (see table on paragraph
lb. 01
..
Message 20 (see table on paragraph
lb. 20
Custom message (modifiable by the user through the App or via modbus)
user.l.
155÷158
Reserved Parameters - Group H
Reserved parameters - Group H
] (degrees for temp. sensors). Default
[digit
p.
, even if the conditions generating it are missing. To be able to act
a.2.de.
A
in correspondence of the relevant output.
: .. :
mm:ss (hh:mm if
.
=
).
AL.2.F .
c. Aux
=
). Default:
AL.2.F .
c. aux
.
)
.
)
: .
User manual - ATR224 - DRR224 - 27
Publicité
