Publicité
Les langues disponibles
Les langues disponibles
134 a. 1 .de.
Alarm 1 Delay
Alarm Delay.
-
: .. :
mm:ss (hh:mm if
Negative value: delay when exit alarm status.
Positive value: delay when enter alarm status.
135 A. 1 .S.p.
Alarm 1 Setpoint Protection
Allows or not to change the alarm setpoint
Editable by the user (Default)
FrEE
Protected
Lock
Protected and not visualized
HidE
136 A. 1 .Lb.
Alarm 1 Label
Selects the message displayed in case of alarm intervention.
Disabled. (Default) 0.
disab.
Message 1 (see table on paragraph
lb. 01
..
Message 16 (see table on paragraph
lb. 16
Custom message (modifiable by the user through the App or via modbus)
user.l.
137÷140
Reserved Parameters - Group G
Reserved parameters - Group G
GROUP H -
AL. 2
141 AL.2.f.
Alarm 2 Function
Alarm selection.
Disabled (Default)
diSab.
Absolute Upper Activation. Absolute referred to the process, active over
Ab.up .A.
Absolute Lower Activation. Absolute referred to the process, active under
Ab.Lo.a.
Band alarm (command setpoint ± alarm setpoint)
bAnd
Upper Deviation alarm
up .dev .
Lower Deviation alarm
Lo.dev .
144 A.2.5.o.
Alarm 2 State Output
Alarm output contact and intervention type.
(N.O. Start) №rmally open, active at start (Default)
n.o. St.
(N.C. Start) №rmally closed, active at start
n.c. St.
(N.O. Threshold) №rmally open, active on reaching alarm
n.o. tH.
(N.C. Threshold) №rmally closed, active on reaching alarm
n.c. tH.
(N.O. Threshold Variation) disabled after changing control setpoint
n.o.tH.V .
(N.C. Threshold Variation) disabled after changing control setpoint
n.c.tH.V .
145 rEs.
Reserved
Reserved parameter.
146 a.2.Hy.
Alarm 2 Hysteresis
Alarm hysteresis
-
..+
[digit
147 A.2.L.L.
Alarm 2 Lower Limit
Lower limit selectable for the alarm setpoint.
-
..+
26 - ATR224 - DRR224 - User manual
AL.1.F .
- Alarm 2
] (degrees for temp. sensors). Default . .
p.
[digit
] (degrees for temp. sensors). Default .
p.
). Default:
=
c. aux
.
)
.
)
: .
2 p. 33
2 p. 33
3 p. 33
3 p. 33
Publicité
