Pixsys ATR224 Manuel Utilisateur page 24

87 Lower Limit Output Percentage 1
L.L.P. 1
Selects min. value for command output percentage.
%, Default: %.
%...
88 Upper Limit Output Percentage 1
U.L.p. 1
Selects max. value for command output percentage.
%... %, Default:
89 Max Gap Tune 1
m.G.t. 1
Selects the max. process-setpoint gap beyond which the automatic tune recalculates PID
parameters of process .
- [digit
90 Minimum Proportional Band 1
mn.p. 1
Selects the min. proportional band
regulation of process .
- [digit
91 Maximum Proportional Band 1
ma.p. 1
Selects the max. proportional band
regulation of process .
- [digit
92 Minimum Integral Time 1
mn. i . 1
Selects the min. integral time value selectable by the automatic tune for the P.I.D. regulation of
process .
. ... . seconds. Default:
93 Overshoot Control Level 1
o.c.L. 1
The overshoot control function prevents this event during device switching on or when the
setpoint is modified.
Setting a too low value the overshoot may not be fully absorbed, while with high values the
process could reach the setpoint more slowly.
Disab.
Lev.
Lev.
94÷97 Reserved Parameters - Group E
Reserved parameters - Group E
24 - ATR224 - DRR224 - User manual
%.
] (degrees.tenths for temp. sensors). Default: .
p.
] (degrees.tenths for temp. sensors). Default: .
p.
] (degrees.tenths for temp. sensors). Default:
p.
. s.
Lev.
Lev.
Lev. (Default)
value selectable by the automatic tune for the P.I.D.
value selectable by the automatic tune for the P.I.D.
Lev.
Lev.
Lev.
.
Lev.
Lev.