Weller WD 3M Manuel D'instructions page 34

16-18
All manuals and user guides at all-guides.com
Activation / deactivation of the special button
The SP Button function can be used to activate the special
button (11), which was deactivated in the factory:
1. Select the menu item SP BUTTON in menu 2.
2. Set the status with the UP or DOWN button
(ON = activate / OFF = deactivate).
3. Proceed to the next menu item with the button ┌ 1 ┐ (back) or
┌ 2 ┐ (forward).
After activation of the special button (11), it can be used to jump into
menu 1. When you exit the last selected function, it is saved by
pressing the special button (11).
Deactivating / activating automatic channel change
This function can be used to deactivate the automatic channel
change, which was activated in the factory:
1. Select the menu item AUTO CHANNEL in menu 2.
2. Set the temperature unit with the UP or DOWN button.
3. Proceed to the next menu item with the button ┌ 1 ┐ (back) or
┌ 2 ┐ (forward).
Activation / deactivation of the special button
The ECO function can be used to activate the ECO button (8), which
was deactivated in the factory:
1. Select the menu item ECO in Menu 2.
2. Set the status with the UP or DOWN button
(ON = activate / OFF = deactivate).
3. Proceed to the next menu item with the button ┌ 1 ┐ (back) or
┌ 2 ┐ (forward).
After activation of the ECO button (8), it can be used to force
standby mode for all 3 channels. The green LED (9) lights up and
the channels are controlled to the set standby temperature.
If a switching holder is being used, the function is reset with removal
of the tool from the holder.
Setting the control characteristics for the WP 120
The HI / LO CONTROL function can be used to set the control
characteristic of the WP 120, which was set to HI in the factory:
1. Select the menu item HI / LO in Menu 2.
2. Set the status by pressing the UP (HI) or DOWN (LO) button.
WD 3M