Weller WD 3M Manuel D'instructions page 28

10-18
All manuals and user guides at all-guides.com
Setting the standby temperature
The standby temperature is automatically set after a temperature
deactivation. The actual temperature flashes in the display.
"STANDBY" appears in the display.
1. Select the menu item STANDBY in Menu 1.
2. Set the setpoint value for the standby temperature with the UP or
DOWN button.
3. Proceed to the next menu item with the button ┌ 1 ┐ (back) or
┌ 2 ┐ (forward).
Setting temperature deactivation (SETBACK)
When the soldering tool is not in use, the temperature is reduced to
the standby temperature after the set setback time has elapsed. The
setback status is indicated by a flashing actual value display and the
message "STANDBY" appears in the display. Pressing the UP or
DOWN button ends this setback status. Depending on the tool, the
finger switch or the switching holder deactivates the setback state.
The following setback settings are possible:
"0 min": setback OFF (factory setting)
"ON": Setback ON (after the soldering iron has been deposited,
the switching holder is used to adjust immediately to standby
temperature).
"1-99 min": setback ON (individually settable setback time)
1. Select the menu item SETBACK in Menu 1.
2. Set the setback value with the UP or DOWN button.
3. Proceed to the next menu item with the button ┌ 1 ┐ (back) or
┌ 2 ┐ (forward).
Setting the automatic switch-off time (AUTO-OFF)
When the soldering tool is not in use, heating of the soldering
tool is switched off after the AUTO-OFF time has elapsed.
Temperature deactivation is performed independently of the set
setback function. The actual temperature flashes in the display and
serves as residual-heat indicator. "OFF" appears in the display.
Below 50 °C (122 °F), a flashing dash appears in the display.
The following AUTO-OFF time settings are possible:
"0 min": AUTO-OFF function is switched off
"1-999 min": AUTO-OFF time, individually settable
1. Select the menu item OFF in Menu 1.
2. Set the AUTO-OFF setpoint time value with the UP or DOWN
button.
3. Proceed to the next menu item with the button ┌ 1 ┐ (back) or
┌ 2 ┐ (forward).
WD 3M