Weller WD 3M Manuel D'instructions page 29

WD 3M
Settings
SETBACK OFF Time [1-
Time [1-99 min] 999 min]
0
0
ON
0
Time
ON
Time 0
Time Time
0 0
ON 0
0 Time
ON Time
Time 0
Time Time
1) Not in use = UP/DOWN buttons not pressed and no temperature drop > 5 °C.
STANDBY temperature must be below the set setpoint temperature, otherwise the SETBACK
2)
function is inactive.
3) When a switching holder is connected, the soldering tool always remains at the set setpoint
temperature outside the holder.
The holder function is activated after the first time the soldering tool is deposited.
All manuals and user guides at all-guides.com
Temperature performance with different settings of the SETBACK
and AUTO OFF functions
Temperature performance without switching holder
Soldering tool remains at the set soldering temperature.
Soldering tool is switched off when not in use
has elapsed.
Soldering tool is controlled down when not in use
temperature
Soldering tool is controlled down when not in use
temperature
off after the OFF time has elapsed.
Temperature performance with switching holder
Soldering is switched off in the holder
Soldering tool is controlled down in the holder
temperature
Soldering tool is switched off in the holder
elapsed.
Soldering tool is controlled down in the holder
temperature
Soldering tool is controlled down in the holder
temperature
The soldering tool is controlled down in the holder
STANDBY temperature
is switched off after the OFF time has elapsed.
Note Reset of STANDBY and OFF modes:
Without switching holder by pressing the UP or DOWN button.
With switching holder by removing the soldering tool from the
holder.
2) after the SETBACK time has elapsed.
2) after the SETBACK time has elapsed and is switched
.
2)
2) and switched off after the OFF time has elapsed.
2) after the SETBACK time has elapsed.
2) after the SETBACK time has elapsed and
after the OFF time
1)
1) to the STANDBY
1) to the STANDBY
3) .
3) to the STANDBY
after the OFF time has
3)
to STANDBY
3)
3) to the STANDBY
3) to the
11-18