Textron Jacobsen Greens King V Plus Manuel De Fonctionnement page 15

5 OPERATION
GB
5.9 MOWING
WARNING
To prevent serious injuries, keep hands,
feet and clothing away from cutting unit
when the blades are moving.
NEVER use your hands to clean cutting
units. Use a brush to remove grass
clippings from blades. Blades can be
sharp and could cause injuries.
To clear obstructions from cutting unit,
disengage reel switch, engage parking
brake, stop engine and remove key from
ignition switch then remove obstruction.
To mow:
1. Start the engine and lower the mowers to
the ground. The lift cylinder must be fully
extended for the mowers to float properly.
Note: To prevent damage to the reel and bedknife,
5.10 TOWING / TRAILERING
If the tractor experiences problems and must be
shut down and removed from the area, it should be
loaded onto a trailer for transport. If a trailer is not
available, the unit can be towed slowly for short
distances.
NOTE: Do not exceed 3.2 KPH while towing. Long
distance towing is not recommended.
Use care when loading and unloading tractor.
Fasten tractor to trailer to prevent tractor from rolling
or shifting during transport.
Before towing, open tow valve. The tow valve
permits moving the tractor without starting the
engine and prevents possible damage to hydraulic
components.
The tow valve (Z) is located on the drive pump
beneath the cowling. To open valve, insert a pin into
the small hole in the tow valve and turn the valve
counterclockwise not more than one full turn.
Close valve completely and replace cover after
towing.
All manuals and user guides at all-guides.com
JACOBSEN GREENS KING V PLUS Series: WA
SAFETY AND OPERATORS MANUAL
never operate reels when they are not cutting grass.
2. Turn reel switch to ON and disengage
parking brake.
3. Move throttle lever to FAST then slowly
depress traction pedal to the desired
mowing speed.
a. For complete even cutting, overlap
swaths by a few inches.
b. Stop and raise the mowers to the
transport position when crossing paths or
roadways. Look out for traffic.
4. To remove or install the grass catchers,
lower the cutting units to the ground,
engage the parking brake, and shut off the
engine. Tilt the grass catcher body so the
front edge clears the mower frame, and
slide the catcher onto or off the catcher
frame.
GB-13