Publicité
Les langues disponibles
Les langues disponibles
1.
Plug the telephone line cord into the socket marked
the base.
2. Plug the power adaptor into the socket marked
base and plug the other end into the mains power wall socket. Switch on the
mains power.
Installing and charging the handset
1.
Remove the battery cover from the back of the handset by placing your finger
in the groove at the bottom of the handset and lifting the cover up to release,
then insert the 300mAh Ni-MH battery pack supplied.
Use your
finger to unclip
the cover and
lift up.
2. Clip the battery cover back into place.
3. When charging the battery pack for the first time, place the handset on the
base to charge for at least 16 hours continuously.
4. When the handset is fully charged,
the other end of the telephone line cord (make sure that one end is already
plugged into the base) into the telephone wall socket.
Getting started
To open:
To close:
Insert your
here.
finger
f
will appear steadily on the display. Plug
on the underside of
on the underside of the
Position the
1
battery
cover as
shown.
2
Lower the
cover and
clip into
place.
7
Publicité
