Publicité
10. Installing the cabin hood
First, insert the rubber bushings (1) into the two borings in
the cabin hood (2) using a small screwdriver.
Make sure that the rubber bushings are not damaged by
the sharp edges of the screwdriver.
Then slide the hood onto the model from the front and
pull the rubber bushings over the support bolts (see ill.
17, pos. 6).
Once you have checked the fit of the cabin hood or
adjusted it if necessary, you can design the cabin hood
with the enclosed decal sheet.
11. Checking the center of gravity
Align the rotor blades at an exact 180° angle towards each other and turn the rotor head in such a way that one rotor
blade points forwards and another one backwards (see ill. 22).
Insert the flight battery and slide on the cabin hood.
If you now pick up the ready to fly helicopter on the left and right of the paddle rod, the model keeps its balance.
Depending on whether you equip your model with a light or a heavy battery, it might be necessary to shift the centre of
gravity by shifting the battery or using additional lead weights.
48
All manuals and user guides at all-guides.com
Figure 21
Publicité
