Publicité
Les langues disponibles
Les langues disponibles
10.2 NIGHT LIGHT REPLACEMENT
Your appliance came equipped with our
"NIGHT LIGHT". The light has been pre-wired
and can be controlled from the switch on the
control panel.
It is recommended that the NIGHT LIGHT
be in the off position when the appliance
is on.
If in the event the lamp or lens needs to be
replaced, follow the instructions below.
Unplug the light from inside the appliance.
Remove the four screws that secure the lens
frame. This frame retains the glass lens. The
lamp can now be accessed.
NOTE: Do not handle the lamp (bulb) with bare
fi ngers, protect with a clean dry cloth.
The lamp will pull straight out of the socket. Replace
with Wolf Steel parts only, as lamp and lens are spe-
cial "high temperature" products.
When re-installing, ensure integrity of gasket seal.
THE FIREBOX MUST BE SEALED.
NOTE: Over tightening the screws could break the lens.
"Light Leakage" from the upper louvre area may be noticed. The holes in the lamp housing are necessary for
ventilation and must not be covered.
10.3 THERMAL SWITCH REPLACEMENT
The thermal switch is located to the left side of the
lower control area, on a bracket and mounted beside
the junction box.
Unplug the blower from the junction box or turn
A.
off the power to the appliance if hard wired.
Remove the fastener. Pivot the bracket out
B.
from the fi rebox side.
Disconnect the slip-on connectors and remove
C.
the thermal switch from the bracket.
All manuals and user guides at all-guides.com
LENS
ASSEMBLY
SCREWS
FIREBOX TOP
THERMAL SWITCH
RECEPTACLE /
JUNCTION BOX
GROUND
SCREW
W415-1103 / A / 08.07.13
41
EN
GASKET
LENS
FRAME
Publicité
