Publicité
Les langues disponibles
Les langues disponibles
EMS:
IEC/EN61000-4-2(ESD)
IEC/EN61000-4-3(RS)
IEC/EN61000-4-4(EFT)
IEC/EN61000-4-5(lightning surge)
IEC/EN61000-2-2 (Immunity to low frequency signals)
UNPACKING
Inspect the EPS upon receipt. The box should contain the following:
(1) EPS Unit x 1; (2) User Manual x 1; (3) Input Power Cord x 1
AUTOMATIC VOLTAGE REGULATOR
Utility power is inconsistent. The EPS increases low voltage to computer safe 230 volts. The EPS
automatically provides battery backup (External battery connection required) if the voltage drops below
140 volts or exceeds 300 volts.
HARDWARE INSTALLATION GUIDE
1.
Your new EPS may be used immediately upon receipt. However, recharging the external battery
for at least 8 hours is recommended to ensure that the battery's maximum charge capacity is
achieved (Charging time varies with capacity and a 100Ah or great battery is recommended). To
recharge the external battery, simply leave the unit plugged into an AC outlet. Your EPS is
equipped with an auto-charge feature. When the EPS is plugged into an AC outlet, the external
battery will automatically recharge. The unit will charge when Battery Switch is ON, whenever
Power Switch is ON or OFF.
2.
DO NOT use with medical or life support equipment. DO NOT use with or near aquariums
as condensation may cause the unit to short out.
3.
After connecting the hard wires, plug the EPS into a 2 pole, 3 wire grounded receptacle (wall
outlet). Make sure the wall branch outlet is protected by a fuse or circuit breaker and does not
service equipment with large electrical demands (e.g. air conditioner, copier, etc...). The warranty
prohibits the use of extension cords, outlet strips, and surge strips.
4.
Press the power switch to turn the unit on. The power on indicator light will illuminate and the unit
will beep once.
5.
If an overload is detected, an audible alarm will sound and the unit will emit one long beep. To
correct this, turn the EPS off and unplug at least one piece of equipment from the battery power
supplied outlets. Wait 10 seconds. Make sure the circuit breaker is depressed and then turn the
EPS on.
6.
To maintain optimum battery charge performance, make the EPS plugged into an AC outlet at all
times. Enabling the switch provides the bypass for charge only.
All manuals and user guides at all-guides.com
INSTALLING YOUR EPS
3
Publicité
